• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.xmyzcy.com
新闻中心当前位置:博亿彩票APP下载-新闻中心
    卷帘门的这四个毛病,你会修吗?
    来源:http://www.xmyzcy.com   时间:2019-6-5 18:25:30
    卷帘门在现在的日常中应用十分的广泛,但是在日常的使用中可能会出现很多的小故障,下面济南卷帘门厂家就给大家总结了以下常见的四种故障,希望对大家有所帮助!
    Curtain door is widely used in daily life, but there may be a lot of minor faults in daily use. Now Jinan curtain door manufacturer summarizes the following four common faults, hoping to help you!
    1、卷帘安装通电后,电机不转或启动缓慢
    1. After the curtain is installed and electrified, the motor does not turn or starts slowly.
    原因及解决办法1:电源与电机的额定电压不符,更换与电源电压匹配的电机或者接入相对应的电源; 2:过载,更换与负载相匹配的电机;3:安装不当而导致零配件卡死电机,检查各部分配件安装是否正确
    Reasons and Solutions 1: The rated voltage of the motor does not match the power supply, replacing the motor matching the power supply voltage or connecting the corresponding power supply; 2: Overloading, replacing the motor matching the load; 3: Installation improper and lead to parts stuck motor, check whether the parts are installed correctly.
    2、卷帘在关闭后又重新弹开
    2. The curtain bounces again after closing.
    解释:卷帘在完全关闭后没有停下来,而是重新弹开,卷帘重新回复开启状态。原因及解决办法:卷帘应该配置了遇阻反弹装置,该情况为遇阻反弹装置故障,请即时联系厂家解决.

    Explanation: The curtain did not stop after it was completely closed, but rebounded and the curtain resumed its opening state. Reasons and solutions: Rolling curtain should be equipped with resistance rebound device. In case of failure of resistance rebound device, please contact the manufacturer immediately.

    卷帘门

    3、工业门振动或噪声较大分析:多是刹车盘不平衡或断裂、刹车盘无紧固、或者轴承失油失效、齿轮啮合不顺、失油或磨损严重、电机电流声或振动。解决办法: 紧固刹车盘螺母; 更换刹车盘或重新调整平衡; 更换电机轴输出端齿轮、润滑油; 更换轴承; 检查电机,若损坏则更换电机
    3. Vibration or noise analysis of industrial doors: most of them are unbalanced or broken brake disc, no tightening of brake disc, or failure of bearing oil loss, bad gear meshing, serious oil loss or wear, motor current sound or vibration. Solutions: tighten the brake disc nut; replace the brake disc or re-adjust the balance; replace the motor shaft output gear, lubricant; replace bearings; check the motor, if damaged, replace the motor.
    4、工业门手拉链不动分析:多是环形链条堵住十字槽、棘爪无脱离棘轮或者压链架卡死导致。解决办法:将环形链条整理顺畅;调整棘爪与压链架相对位置或更换润滑销轴。
    4. Fixed analysis of industrial door hand zipper: Most of them are caused by the ring chain blocking the cross groove, the pawl without detaching from the ratchet wheel or the chain holder jamming. Solution: arrange the ring chain smoothly; adjust the relative position between the pawl and the press chain frame or replace the lubrication pin shaft.
    以上便是今天由济南卷帘门厂家为大家整理分享的精彩内容了,大家可以收藏我们的官网:http://www.xmyzcy.com 来了解更多的前沿资讯,谢谢大家!
    The above is the wonderful content that Jinan curtain door manufacturer organizes and shares for you today. You can collect our official website: http://www.xmyzcy.com to learn more frontier information. Thank you!
河北快3开奖直播 伯爵彩票APP 爱彩彩票APP下载 河北快3走势图 河北快3走势图 博易彩票APP下载 百万彩票APP 泊利彩票APP下载 宝马彩票APP下载 博亿彩票APP下载