• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.xmyzcy.com
新闻中心当前位置:博亿彩票APP下载-新闻中心
    安装无框玻璃门的小细节!
    来源:http://www.xmyzcy.com   时间:2019-8-29 14:53:22
    无框玻璃门的安装方法与一般的玻璃门安装方法差不多,可是也有一些区别,下面济南玻璃门的小编就给大家总结几天安装无框玻璃门应注意的小细节!或许你会用的上。
    The installation method of frameless glass doors is similar to that of ordinary glass doors, but there are also some differences. The following edition of Jinan glass doors will summarize the details of installation of frameless glass doors in a few days. Maybe you'll use it.
    1、安装无框玻璃门门框顶部限位槽:由所弹中心线引出两条金属装饰板边线,然后按边线进行门框顶部限位槽的安装。
    1. Install the top limit groove of frameless glass doorframe: Two metal decorative plate edges are drawn from the projected center line, and then the top limit groove of the door frame is installed according to the edge line.
    2、安装无框玻璃门金属饰面的木底托:在原预埋木砖上钉方木,或通过膨胀螺栓钉方木,把方木固定在地面上,然后再用万能胶将金属饰面板粘在木方上。
    2. Install wooden underpinnings with metal decoration for frameless glass doors: nail the square wood on the original embedded wood bricks, or fix the square wood on the ground by expanding bolts, and then glue the metal decoration panel onto the wood with universal glue.
    3、无框玻璃门的玻璃门扇安装:用玻璃吸盘器(或玻璃吸盘机)把厚玻璃吸紧吸住,然后手握吸盘把通过2~3人把厚玻璃板抬起并竖立起来移至安装地点准备就位。

    3。 Installation of glass doors with frameless glass doors: use glass sucker (or glass sucker) to absorb the thick glass, and then hold the sucker in hand to lift the thick glass plate through 2-3 people and move it to the installation site to be ready for positioning。

    济南玻璃门

    4、玻璃固定:在底托木上的内外钉两根扁方木条把厚玻璃夹在中间,但距厚玻璃板需留出4mm左右的空隙,然后在扁方木条上涂刷万能胶将饰面金属板粘卡在方木和两根扁方木条上。
    4. Glass Fixation: Two flat square wooden bars are nailed on the base timber to clamp the thick glass in the middle, but the gap is about 4 mm away from the thick glass plate. Then the decorative metal plate is stuck on the square timber and two flat square wooden bars by applying universal glue on the flat square wooden bars.
    5、注玻璃胶封口:在顶部根位槽两侧空隙内和底托玻璃槽口的两侧以及厚玻璃与门框柱的对缝处注入玻璃胶。
    5. Glazing sealant: Glazing sealant is injected into the voids on both sides of the roof groove at the top and the glass groove at the bottom, as well as into the seams between the thick glass and the door frame column.
    6、无框玻璃门的玻璃之间对接:固定部分的厚玻璃板,由于宽度尺寸过大,必须用两块或两块以上进行拼装而成,两块对齐拼接必然形成接缝,对接缝应留2~3mm的距离。
    6. Docking between glass of frameless glass door: Thick glass plate of fixed part must be assembled with two or more pieces because of its large width and size. Alignment and splicing of the two pieces will inevitably form joints, and the distance between the joints should be 2-3 mm.
    今天就暂且和大家聊到这里,希望这篇由济南玻璃门的小编整理的知识可以帮助到您,如果您对此还有疑问,详情请咨询我们的官方。http://www.xmyzcy.com
    Today I'm going to talk to you for a moment. I hope this little Tidy-up knowledge from Jinan Glass Gate can help you. If you have any questions about it, please consult our official for details. Http://www.xmyzcy.com
河北快3开奖结果 博易彩票APP下载 宝马彩票APP下载 伯爵彩票APP下载 奔驰彩票APP下载 博美彩票APP下载 博亿彩票APP下载 博美彩票APP下载 河北快3开奖直播 爱购彩票APP