• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.xmyzcy.com
新闻中心当前位置:博亿彩票APP下载-新闻中心
    降低卷帘门噪音的方法有哪些?
    来源:http://www.xmyzcy.com   时间:2019-9-18 18:17:03

    卷帘门在打开和关闭时会发出嘎嘎声、吱吱声和尖叫声,这很烦人。下面济南卷帘门厂家就给大家总结几条降低卷帘门的噪音的方法,希望对大家有所帮助!

    The screeching, squeaking and screaming of curtain doors when they are opened and closed are annoying. The following Jinan curtain door manufacturers will summarize several ways to reduce the noise of curtain doors, hoping to help you! 

    让卷帘门安静下来的初步是拧紧门和轨道上的螺母和螺栓。确保一切都很舒适。小心不要过紧。

    The initial way to calm the rolling shutter door is to tighten the nuts and bolts on the door and track. Make sure everything is comfortable. Be careful not to worry too much.

    卷帘门有活动部件,需要维护。用润滑剂喷洒弹簧顶部,使用足够的油或润滑剂向下流到弹簧底部。喷涂每个履带的内部和所有金属辊的周围。如果有链条组件,润滑链条。观察并确定链条是否容易绕齿轮滑动。喷涂所有面板之间的铰链。任何运动部件都会引起振动。通过每年至少润滑运动部件两次,将车库噪音降至更低。使用喷雾润滑剂时要自由。

    The rolling shutter door has movable parts, which need to be maintained. Spray the top of the spring with lubricant and use enough oil or lubricant to flow down to the bottom of the spring. Spray inside each track and around all metal rollers. If there are chain components, lubricate the chain. Observe and determine whether the chain is easy to slide around the gear. Spray all hinges between panels. Any moving part will cause vibration. Reduce garage noise to a lower level by lubricating moving parts at least twice a year. Use spray lubricants to be free.

    检查卷帘门上的滚轮。如果金属滚轮沿着金属轨道移动,会产生很大的噪音。尼龙滚轮比金属滚轮安静得多,不需要润滑剂,维护也更少。尼龙车库滚轮不会贵太多,而且噪音降低值得额外的钱。

    Check the rollers on the shutter door。 If the metal roller moves along the metal track, it will produce a lot of noise。 Nylon rollers are much quieter than metal rollers, require no lubricants, and maintain less。 Nylon garage rollers are not too expensive, and noise reduction is worth the extra money。

    济南卷帘门

    用作卷帘门和开门器缓冲器的橡胶片将有助于降低噪音。在操作门和开门器之前,拔掉开门器的电机。在门下面放一把结实的梯子,把门放在梯子上。将开门器电机从安装支架上拆下,轻轻放在地板或工作台上。拆下卷帘门上固定轨道的螺栓。在门和螺栓之间滑动一块大约1/4英寸宽的橡胶。拧紧螺栓。

    Rubber sheets used as buffers for rolling shutters and door openers will help reduce noise。 Before operating the door and the door opener, unplug the motor of the door opener。 Put a strong ladder under the door and put the door on the ladder。 Remove the door opener motor from the mounting bracket and gently place it on the floor or worktable。 Remove the bolts of the fixed track on the rolling shutter door。 Slide a piece of rubber about a quarter of an inch wide between the door and the bolt。 Tighten the bolt。

    在使用螺栓和垫圈后,您可能需要重新调整卷帘门锁。检查以确保锁杆没有错位。注意锁杆碰到轨道,发出噪音,不要卡住。当你的门上下移动时,错位会引起摩擦噪音。找到附在门上的L形引线支架。松开螺钉,向上或向下轻敲导轨;根据对齐方式,拧紧螺栓和螺钉,并在另一个导轨上重复。

    After using bolts and washers, you may need to readjust the curtain door lock. Check to ensure that the lock rod is not misaligned. Pay attention to the lock rod touching the track, make noise, don't get stuck. When your door moves up and down, misalignment can cause friction noise. Find the L-shaped lead bracket attached to the door. Loosen the screw and tap the guide upward or downward; tighten the bolt and screw according to alignment and repeat on another guide.

    感谢您的阅读与观看,本文的精彩内容来自:济南卷帘门,我们会有更多的精彩内容继续为您呈现,详情请点击:http://www.xmyzcy.com

    Thank you for your reading and watching. The wonderful content of this article comes from: Jinan Curtain Door. We will continue to show you more wonderful content. For more details, please click: http://www.xmyzcy.com.


河北快3开奖直播 博牛彩票APP下载 博易彩票登陆 宝乐彩票平台 博美彩票APP下载 宝赢彩票APP下载 河北快3开奖结果 必中彩票APP下载 必中彩票注册 博亿彩票APP下载